How to repair a garland yourself: tips and tricks
New Years is soon! You put the Christmas tree and decided to dress it up ... Pull out the forgotten box with New Year's toys and hang an electric garland on the fluffy branches. And suddenly, what a misfortune, you notice that it does not work. On the garland one lamp burned out, while others continue to glow or, conversely, do not burn everything. I wonder why? How to be in this case? What to do? Go to the store for a new garland? The option is the simplest, but not always feasible. Do not rush to throw out the old one, as, it is likely, it can be repaired. How to repair a Christmas tree? Fortunately, they all have typical circuits and are simple in the device. Next, we will tell you how to repair the Christmas tree garland, if the light bulb is burnt out, the contact wires come off or the mode does not work.
What should be considered?
The main thing is to know in what order ingarland all the bulbs are connected. How here to find a problem place? In order to find faults in the circuit, you can use an indicator screwdriver. If you do not have one light, it means that in this case a parallel connection is used in the garland circuit. Fixing a malfunction is not difficult, you just need to replace the light bulb.
Chinese garland
And how to repair the Chinese garland? It differs in that it is non-separable, disposable and has fixed bulbs. There is a chain of garlands of four colors, flashing alternately. If one color does not work, what should I do?
LED garland
The design of the LED garland is such that,burns as a rule, the program, and the diodes themselves remain. And throw it away ... How to repair a garland LED? If the lamps do not shine, then you should inspect everything where there may be a breakdown. Check the integrity of the cord. Or maybe the contact on the chip has disappeared or the chip itself has burnt out.
The Soviet garland
Consider the old Soviet products, whichregularly serve more than one generation. They certainly just throw out a pity. How to repair a garland of this kind? To do this is not too difficult. Using a tester, you need to measure the resistance of each lamp and thus find a burned out one.
How to repair a garland: a few more tips
If you have a light bulb in a garland,it's faster and easier to change them yourself. But first, pull the cord out of the socket. To prevent electric shock, replacement of lamps is required only with power off.
When repairing a garland, if at hand was notyou need to cut off the malfunctioning microlamp. And connect the wires manually or by special connectors. Do not forget to isolate the ends of the contacts!
- it is necessary to check the plug, perhaps the wires have been frayed;
- the connection of the contact with the lamp holder was interrupted;
- it is possible that the cause is in the burned light bulb;
- it is very likely that the fuse blows out or the garland circuit itself is malfunctioning;
- the problem can also be in the controller, if the lamps on the garland do not blink and the switching modes do not work;
- also wanted to draw your attention to the fact that if the LED burns in a garland, the whole section stops working. Therefore, when soldering the desired LED, strictly observe the polarity.
That's all I wanted to tell you about howrepair the garland, if suddenly one lamp will cease to burn or everything, how to proceed, if the board wipes out. Now you know how to fix it yourself and what you need to do for it.
</ p>>