How to make Kerambit with your own hands

Many today are interested in the issue ofHow to make kerambit at home. And it is necessary to make it was possible from improvised elements, without using expensive factory materials.

Manufacturing technologies

How to make kerambit? Manufacturing technology is very easy and simple. To start, you need a disk from the circular saw. It is necessary to clean it of rust and grease, using sandpaper. Then with the help of gasoline it is necessary to conduct a complete degreasing.

For these purposes, you can use absolutelywith any solvent. Degreasing is necessary to ensure that the protective layer of the varnish is kept well and does not fall off during electrical corrosion. You can use nitrocellulose varnish. It is good because it keeps perfectly on the surface of the product and dries very quickly. For best effect, it is necessary to apply three coats of varnish on each side of the disc. Apply the varnish with a brush.

But if there were no brushes at home? Then how to make kerambit? It does not matter, since you can use your usual earwax. The necessary model of Kerambite can be found in the shortest possible time. For convenience, you can print a drawing that shows a kerrambite (drawing) so that it is always in front of your eyes. Then you need to cut out the drawing of the knife neatly. And with the help of undiluted nitrolac paste the cardboard knife to the steel disc. We circle the tin wire, which we connect to the minus contact from the power supply and, of course, to the disk itself. The wire can be fixed with a super glue, which will perfectly cope with this task.

Preparation

Then circle the model of the knife all over its area andprepare for the oxidation process. It is quite long, but noiseless, which is a positive moment in this matter. An electrochemical reaction must be carried out until the knife model separates from the steel disc. Three lengthy reactions of this kind are enough to achieve the desired effect. The knife after such manipulations is fairly easily separated. Then with the help of nazhdachki and file or a special electric tool you need to go to the process of turning the knife and bringing it into an ideal shape.

Then, using a grinding tool, grinding is necessary from both sides of the knife.

How to make a handle for kerambita

How to make kerambit with ease? In order to make a handle for a knife of Kerambite, it is necessary to use high-strength material. In this case, the Getinax is very suitable - a resistant high-strength plastic. In addition, it is very easy to process. You can cut it with a hacksaw for metal. The surface of the lining of the handle must be treated with coarse sandpaper.

On the surface of the handle of Kerambite we apply a saltacid for pickling. The completion of the reaction can be determined from the matte surface of the metal. The reaction products can be rinsed with ordinary cold tap water. Then carefully dry the knife and apply epoxy. Also, it should be applied to the lining for the handle. When heated, there will be an excellent gluing. After the final grinding of the knife to give a beautiful view. And in the end it will be possible to rejoice at the knife of Kerambita, made by own hands.

Precautionary measures

In this case, you must understand that itcan be easy for those who are familiar with the turning process and are well versed in metals and all sorts of chemical reactions. When applying epoxy resin on a knife, you need to be careful not to touch with your bare hands. Carry out grinding neatly. This kind of business needs to be implemented in a room that is well ventilated.

</ p>>