How to make daytime running fire with your own hands?
What is required?
To begin with, it is necessary to determine the place wherean DRL system will be installed. It should be remembered that it's easy enough to make daytime running fire with your own hands, it's important to only consider several rules and requirements. For example, the height restrictions (at least 250 mm from the ground surface) and width (no more than 400 mm from the side edge of the car) must be observed.
Once the exact location of the installation is selected, you canproceed to the practical part. First of all, all the details involved in the process will be required. This event directly depends on what and how it is arranged under the hood of your car. Therefore, daytime running lights can only be installed with your own hands if you know enough about your car. After that, all necessary measurements are made, on the basis of which the marking of the DRL location will be carried out in the future. At this stage it is very important to keep the symmetry of the structure. After similar preparations it is possible to mount daytime running fire with your own hands. A set of LEDs is attached to the selected points, then all necessary wires are attached. Traditionally, such a system is attached to the ignition key, so that DRL started to work when the engine starts, and turned off when the headlights are switched on. Thus, the daytime running light (with your own hands, for example, installed) is responsible for your safety even when you do not know about it.</ p>>