Fixtures for a bath

Thanks to the fact that electricity without problemsis brought to modern saunas, lately all the bathing procedures have no longer needed to be carried out before dawn and "in a hurry." Large windows that produce heat from the room, successfully replace special lamps for the bath, which must be heat-resistant and airtight.

Protection class for switches and sockets in humid conditionsrooms should be higher than IP-44. The luminaire for a bath must have an index not lower than IP-54. In this case, in the steam room and the washing room, there should be no outlets or lights. They can be mounted only in the waiting room and rest room at a height of not less than 80 cm from the floor level.

Features

Fixtures for a bath are functionally different fromany lighting equipment for other rooms, particularly residential and domestic rooms. Their strength characteristics should be high, they must be equipped with modern capacitors or a throttle that regulates the voltage in the lamp. High humidity in the room affects the devices in a bad way, so all lamps for the bath and the lamp must be protected from significant temperature changes by fluorescent starters and a sodium driver for LEDs.

The problem is that for a sauna and a bathtypical high air humidity, reaching 85% at particularly critical temperatures. Such an explosive mixture of hot and humid air negatively affects lighting fixtures, not all models of lamps and fixtures can work long and correctly under such conditions. Therefore, lighting in the bath should include the use of modern special models of devices containing an igniting or impulse device. Starters should choose luminescent or sodium.

To protect against water ingress, all luminaires forbaths are equipped with a reinforced housing that protects starters, driver for LEDs and other pulse and igniting devices from the occurrence of fire and short circuit. This is extremely important for wooden buildings, since even a small spark can destroy everything completely in a few minutes. Fixtures for the bath should be protected from condensation, so the samples of the lamps are covered with sodium shells, which protect the ignitor from the vapor. Pulse and special lighting equipment is equipped with modern methods of protection from high temperatures, moisture settling and other causes of short circuit. Fixtures for a bath are equipped with a sealed lampshade, which includes a driver and an LED starter that reliably protects against the penetration of excessive moisture.

At the same time, high temperature is not dangerous for yourigniting or impulse device, on the contrary, promotes slow cooling of the device. To resist a high temperature difference and to protect from moisture, lamps with a glass lampshade, including LED fluorescent starters and ballasts, can be used.

</ p>>