How to build a fence of corrugated board with your own hands? A little bit about this difficult matter

On any site, an indispensable element isfence. The best solution is to build a fence made of such material as corrugated board, since you do not have to spend a lot of money and energy. But it is worthwhile to understand that corrugated board is the same material. And this is what limits some of the design ideas. But the uniformity is saved by a large color gamut, which helps harmoniously fit the fence into any landscape. And if you properly mount a fence of corrugated board, it can last more than 30 years. So, how to build a fence of corrugated board with your own hands?

Building a fence with your own hands from thismaterial under the power of everyone. Assembly and installation can easily be done by yourself. In order to solve the problem of "how to build a fence from the corrugated board with our own hands," we will need metal pipes for posts, slightly smaller diameter pipes for the crossbeams and directly the material itself of a suitable size. In order to fasten the sheets, you need only a drill and screws.

The foundation is the basis of the fence. And if you decide to learn about how to build a fence of corrugated board, then forget about it is not necessary. It is from it will depend on the strength of the design. To its construction should be approached with a large share of responsibility. Otherwise, you will not be too pleased with the short life of your fence. It should be understood that the heavier the material for the fence installation is chosen, the firmer the foundation must be.

The next step of such a responsible process asinstallation of a fence of corrugated board with your own hands, is to create a markup for the future structure. To do this, we hammer wooden pegs into the ground. Then a very strong twine or wire is stretched between them. Then dig a trench, the width of which is approximately 40 cm across the entire area where the foundation will be located. It is necessary for the pillars to make pits with a width of 40 cm approximately three meters apart. On both sides of the trench, it is required to put a wooden plank on its edges. For the strength of the foundation, welded iron reinforcement is laid in the trench. After this, pour concrete.

After you pour the solution, you needWait a while until it dries completely. It will last approximately one week. After the foundation has been prepared, it is possible to proceed to the final stage of the solution of the problem "how to build a fence of corrugated board by one's own hands". You will need to start installing the sheets. They are attached to special veins of metal. To do this, you should weld the pipes to the ready-made posts from above and below. The distance between them does not need to be made too large. Otherwise the corrugated sheet will bend. After the pipes have been welded, it is necessary to start fixing the sheets. This must be done with the help of self-tapping screws. The distance between the fastening systems should not be less than twenty centimeters.

This is the question "how to build a fence of corrugated board with your own hands" can be considered considered. Good luck in creating a fence!

</ p>>