How to make plasterboard ceilings: recommendations
Before talking about how to make ceilings fromgypsum board, you need to talk about what this material represents. Let's figure it out. Gypsum cardboard is the most demanded material intended for interior finishing of any premises in which a low level of humidity is noted. It can be used for the organization of partitions, slopes, as well as for leveling ceilings and walls. If you make a suspended ceiling from gypsum board, it will be a quick convenient way to get a flat surface. Before proceeding with the installation of such a system, it is necessary to clean the surface of old coatings, and the joints of the boards should not be puttyped, since the new ceiling will hide all these shortcomings.
Before starting to fix the sheets of material,It is necessary to build a framework of the future design. First, you need to mark the perimeter on the wall, for which the hydraulic level is useful. Along the received line it is necessary to fix the UD-profile. With a small area of the room it is enough to insert several SD-profiles into it, which will be cut to size. With the help of screws on them, you can fix the sheets of material. Such a technique is inappropriate in a room where the ceiling area is large enough, because of the heavy load it can sag. If we talk about how to make a ceiling from gypsum board in this case, it is appropriate to note that the profile through a certain distance should be fixed to the ceiling by means of special hangers. Level control can be done with a stretched line.
You can make a two-level ceiling fromdrywall. To do this, you need to think in advance of the outlines of the future design. It is necessary to make patterns from a cardboard of the demanded form that then correctly to make and fix details. Such ceilings look quite impressive, allowing you to create a unique interior. Such multi-level structures can be used together with tension ceilings. If you are wondering how to make plasterboard ceilings in this case, it is necessary to say that along the line that is marked on the first tier, it is necessary to fix the radius profiles that are made from conventional profiles using metal scissors. To do this, you need to cut through every couple of centimeters, and then bend the profile. It then needs to be fixed to the first level in those places where there are stiffeners, and after that the stiffeners are mounted similarly to the first level. The patterns can also be used for patterning plasterboard elements, which then need to be fixed to the profile. The fastening is performed with the help of special screws with cone-shaped hats, which will allow them to hide in the drywall.
